Fast! Easy! Neat! |
 |
Support the Rabbetspace in the mitering device with a mitered strip of wood the same thickness as the offset in the Rabbetspace. (These wood strips are available from Frame Tek) |
 |
Position the wood strip back just a little so you don't cut it each time. Sticking the wood strip down to the base of your saw with ATG tape will help a lot. |
|
In the empty frame, drill one 1/16" pilot hole 1/4" deep and 3/32" clearance hole through just the plastic near the corner and attach the Rabbetspace temporarily with a screw at the corner. (A clearance hole is necessary to prevent buckling from expansion.) A special drill is available from Frame Tek that drills both holes at the same time. Now drill all the rest of the holes for that side. Make sure that the inside of the Rabbetspace is flush with the inside of the frame when you drill each hole. |
